Skip to main content

Setting up INFRA Master, Mini, Micro

Sigicom AcademyProductsDiscontinued productsINFRA Master/Micro/Mini

Setting up INFRA Master, Mini, Micro

Before starting the INFRA Master/Mini/Micro, please make sure to have the sensors connected

Start-up

  1. Press F1/LCD to start the LCD display.

  2. If REG is OFF, this Start-up menu is shown for 10-30 seconds. INFRA Master/Mini/Micro now connects to all nodes to read their type, serial no., and individual settings. (The lower right text is debug information.)

  3. When all parts of system are connected, a status menu will be shown for some seconds (can be bypassed by pressing F2). Possible warnings and non- standard settings are shown with alternating flashing texts.

Two working modes

REG OFF

All connected nodes are passive with no data registration happening. INFRA Master/Mini/Micro automatically shuts off after a few minutes when idle, to save battery power

REG ON

All connected nodes measure & register data according to their individual specs. and settings. INFRA Master/Mini/Micro automatically shuts off after a few minutes when idle, to save battery power but data registration continutes

Toggling REG ON/OFF with Quick Reg ON

  1. From the Main Menu, hold [F1] and [F2] simultaneously for 7 seconds to toggle between REG ON and REG OFF.

  2. The Master automatically returns to the Main Menu.

Toggling REG ON/OFF with Quick Reg OFF

  1. In the Master Unit category enter Working Mode Setup, which is the first menu in this category.

  2. The password is a sequence of [UP] and [DOWN] presses: ▲ ▼ ▲ ▼ ▼ ▲ ▼ ▲

  3. Press [F2] to Edit.

  4. Press [DOWN] to change OFF to ON, or vice versa.

  5. Press [F2] to Save the new setting.